By-pass Adapter

The by-pass called ADORI allows to restore the original motorbike conditions, by simply removing the add-on module, not the wiring though. Thanks to the adapter, the connections between inputs and outputs of the Rapid Bike wiring sections dedicated to injection and pick-up signal are restored. In case of failure, bypass adapter is a valuable tool to test the wiring without having to remove the system.

Digitally adjustable pressure/tension strain Gauge/Loadcell quick shifter.

No movable parts, designed to ensure maximum longevity even under the heaviest use like endurance races. Can be set up for either push or pull linkages. Preload adjustable 1 to 30 with a user friendly digital LED interface. Use a 20MHz processor for an absolute stable up shift signal in all riding conditions. 100% waterproof. Prototypes has been tested to 603.000 activations with 45 kg force, like 12 years o fuse.

Dimensions:

• Length 45mm
• Diameter 14mm

This product is intended for use on racing vehicles on traffic-closed streets

Handlebar map selector

The handlebar map selector is a useful accessory that combined with the Rapid Bike 3 or Rapid Bike 1 (for Atv / scooter) allows you to change the mapping of the add-on module. With the Rapid Bike 1 two injection maps can be changed, with the Rapid Bike 3 the switch allows you to change both the set of injection and the set of advance in two different modes: racing - rain, with db killer - without db killer; more lean - more rich, etc..
Moving the selector position from 1 to 2 or vice versa, the setting changes to achieve always the best performance.

Lambda probe disabling devices

The disabling devices close the electrical circuit dedicated to the lambda probe; they are applied together with Racing-type exhaust, without lambda probe pre-setting, which is disabled from the racing-type system, thus avoiding, in some cases, the anomaly registered by ECU and the consequent lighting of the dashboard lamp and greater power delivery at very low revs (from 1,800 to 3,500 rpm from 0 to 20% tps).

Bluebike Kit

The Blue Bike software kit allows communication between pc, palmtop or mobile phone and the Rapid Bike add-on module within 50mt radius , as the crow flies in open space, by using the Bluetooth technology. The revolutionary system consists of a Bluetooth sensor, which uses the special connector to the Rapid Bike add-on module and a Rb pro software that can be installed on a PC (Windows XP or Vista), Pocket PC Phone and Pocket PC (Windows Mobile 6, 5, 2003 SE) and Smartphone (Windows Mobile 6, 5).

Rapid Bike Lite

This is the software version specifically designed for the end user who is willing to interact with his add-on module. Compared to the PRO version, the screen and the operating principle are the same, except certain restrictions that make it a safer tool in the hands of non-expert users. These limitations are defined in the table on the side.

Differenze fra software Lite e Pro 1.2.142

FUNCTIONS	PRO	LITE
GRAPHICS AND MAPS
RPM AND STATUS
SENSORS
FIND MAPS
PUMP CORRECTION
THROTTLE CALIBRATION
WIZARD EDITOR
MAPS COMPARE
LOCK/UNLOCK MAPS
GRAPHIC
MODIFY RPMS IN MAP
MANAGE LOAD STEPS
USB SETTINGS
HELP
BLUEBIKE
MANAGEMENT PICK-UP SIGNAL
MANAGEMENT RB-O²
HOLD RPM
MANAGEMENT ELECTRONIC GEARBOX SENSOR
RPM LIMITER
MAX ADVANCE ADJUSTABILITY OVER STOCK	+10 / -10	+3 / -3
MAX FUEL ADJUSTABILITY OVER STOCK	+100 / -100	+30 / -10
MAP CONFIGURATION RBIKE3
AUTOMATIC MAPS DOWNLOAD AT STARTUP PROGRAM